Kenwood TK-8302E Manual do Utilizador

TK-7302/ TK-8302© B62-2169-10 (E)09 08 07 06 05 04 03 02 01VHF FM TranscEiVEr/ UHF FM TranscEiVEr insTrUcTion ManUalÉMETTEUr-rÉcEPTEUr FM VHF/ ÉMETTEU

5BASIC OPERATIONSSwitching power on/ oFFPress to switch the transceiver ON.• A beep sounds and the display illuminates.• If the Transceiver Passwo

6SCANScan monitors for signals on the transceiver channels. While scanning, the transceiver checks for a signal on each channel and only stops if a m

7ScAn reVertThe Scan Revert channel is the channel selected when you press the PTT switch to transmit during scan. Your dealer can program one of the

8StunThis function is used when a transceiver is stolen or lost. When the transceiver receives a call containing a stun code, the transceiver becomes

9FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTIONFleetSync is an Alphanumeric 2-way Paging Function and is a protocol owned by Kenwood Corporation.SelcAl

105-TONE SIGNALING5-tone Signaling is enabled or disabled by your dealer. This function opens the squelch only when the transceiver receives the 5 to

11n Lone Worker Mode Lone Worker Mode is a safety feature built into the transceiver. If the transceiver is not operated for a pre-programmed perio

12monitor/ SQuelch oFFYou can use the key programmed as Monitor or Squelch Off to listen to weak signals that you cannot hear during normal operation

13BACKGROUND OPERATIONStime-out timer (tot) The Time-out Timer is used to prevent you from using a channel for an extended duration. If you continuou

VHF FM TranscEiVEr/ UHF FM TranscEiVErTK-7302/ TK-8302insTrUcTion ManUalEnglisHFirmware CopyrightsThe title to and ownership of copyrights for rmware

Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collect

iThank YouWe are grateful you have chosen Kenwood for your personal mobile applications.This instruction manual covers only the basic operations of yo

iiCONTENTSGETTING STARTED ...1GETTING ACQUAINTED ...

1GETTING STARTEDNote: The following instructions are for use by your Kenwood dealer, an authorized Kenwood service facility, or the factory.Supplied

2M4 x 6 mm Hex-headed screwDC power cableMounting bracketAntenna connectorPower input connectorFuseBlack (–) cableRed (+) cable12 V vehicle batteryOp

3=B> 28ACC.:@.;GETTING ACQUAINTEDFront/reAr pAnel① (Power) switch Press to switch the transceiver ON or OFF.② / keys Press to activ

4diSplAyThe display shows the channel number and the 2 dots show various modes of operation.The left and right dots on the display can be programmed t