Kenwood TK-7360E Manual do Utilizador

TK-7360/ TK-8360VHF FM TRANSCEIVER/ UHF FM TRANSCEIVERINSTRUCTION MANUALÉMETTEUR-RÉCEPTEUR FM VHF/ ÉMETTEUR-RÉCEPTEUR FM UHFMODE D’EMPLOITRANSCEPTOR F

5PROGRAMMABLE FUNCTIONSThe , , , , , S, A, <B, C>, and n keys can be programmed with the functions listed below. Ask your dealer for deta

6BASIC OPERATIONSSwitching power on/ oFFPress to switch the transceiver ON.• A beep sounds and the display illuminates. If the Power-on tone selec

7trAnSmitting/ receiVing1 Select your desired zone and channel.2 Press the microphone PTT switch and speak into the microphone to transmit. Release

8ScAn delete/AddYou can add and remove zones and/or channels/group IDs to and from your scan list.1 Select your desired zone and/or channel/group ID.

9n Storing an Autodial Entry1 Press the key programmed as Autodial Programming.2 Press / (if the key assignment list selection is congured as “En

10SIGNALINGQuiet tAlk (Qt)/ digitAl Quiet tAlk (dQt)Your dealer may have programmed QT or DQT signaling on your transceiver channels. A QT tone/ DQT

112 Press the key programmed as Selcall.3 Press / (if the key assignment list selection is congured as “Enabled”) or <B/C> to select the ID

12n Transmitting1 Select your desired zone and channel.2 Press the key programmed as Selcall or Selcall + Status.3 Press / (if the key assignment

134 Press S to enter Status mode.5 Press / (if the key assignment list selection is congured as “Enabled”) or <B/C> to select the status ID

14• When the transceiver enters Emergency mode, the transceiver will change to the Emergency channel and begin transmitting based on how the transcei

VHF FM TRANSCEIVER/ UHF FM TRANSCEIVERTK-7360/ TK-8360INSTRUCTION MANUALENGLISHFirmware CopyrightsThe title to and ownership of copyrights for rmware

152 Press / (if the key assignment list selection is congured as “Enabled”) or <B/C> to select your desired scrambler code.3 Press S, , or

16public AddreSS (pA)The PA system can only be used with an external speaker.1 Press the key programmed as Public Address to activate the Public Addr

17• “BUSY” appears on the display when you press the PTT switch. Use a different channel or wait until the channel becomes free.If your dealer has p

183 Press the S, n, or key to end the recording at any time and store it into the transceiver memory.• If the memory becomes full, recording will

Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collect

iThank YouWe are grateful you have chosen Kenwood for your personal mobile applications.This instruction manual covers only the basic operations of yo

iiCONTENTSGETTING STARTED ...1GETTING ACQUAINTED ...

1GETTING STARTEDNote: The following instructions are for use by your Kenwood dealer, an authorized Kenwood service facility, or the factory.Supplied

2n Installing the TransceiverFor passenger safety, install the transceiver securely using the supplied mounting bracket and screw set, so the transce

3GETTING ACQUAINTEDFront And reAr ViewS① (Power) switch Press to switch the transceiver ON or OFF.② / keys Press to activate their programmable f

4diSplAyIcon DescriptionDisplays the signal strength.Not used.Lights when the GPS position is determined.Signaling is turned off.A DTMF call is being