Kenwood DNN 9150 DAB Manual de Instruções Página 129

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 128
128
Return to the Top page
Controlling Audio
Crossover network setup
You can set a crossover frequency of
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X’over].
X’over screen appears.
3
Set each item as follows.
TW (Tweeter) Gain *
1
Adjust the tweeter level. (When front is
selected on Speaker Select screen)
Gain
Adjust the front speaker, rear speaker, or
subwoofer level.
Phase *
2
Set the phase of subwoofer output.
The phase is reversed 180 degrees when set
to “Reverse”. (When subwoofer is selected on
Speaker Select screen)
HPF FREQ
High Pass Filter adjustment. (When front or rear
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope *
3
Set a crossover slope.
*
1
Only when Tweeter” is set to “Small”,
“Middle”, “Large” in <Speaker Setup>.
*
2
Only when “Subwoofer” is set to a mode
other than “None” in <Speaker Setup>.
*
3
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than Through” in <X’over>.
Ñ
Car type setup
You can setup the car type and speaker
network, etc.
1
Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.
2
Select your car type from the list.
NOTE
If your car type is selected, the Delay Time
Alignment is set automatically (for timing
adjustment of sound output for each channel) to
have the highest surround effects.
Vista de página 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 163 164

Comentários a estes Manuais

Sem comentários