Kenwood 1070VR Manual do Utilizador descarregar pdf (Página 40)

Hold your remote to the speaker portion of

your telephone.

» For each setup code the operator can supply a setup code number.

Should you ever need to change your input configuration, this number

can be used. Please record foryourfuture reference. If for some reason

this information is lost, see "Checking a setup code" in the "Setup code

correlation" section lor further information.

Code selection after mode download

After successful completion of the download, step 5 above, the remote control automatically enters a special set-up mode which works

as described below.

Select the component for which you want

to register the information downloaded

above.

VIDEO key

^ Ф VIDE01 (VCR 1)

® VIDE02 (VCR 2)

— Гз) VIDEOS (LD)

AUDIO key

® CD (CD)

@ TAPE/IVID

(TAPE)

PHONO

TV key

Г» C0TV1

CD TV2

L- CD CABLE

* Example 1 : To register a code at the component connected to the

VIDEO 1 jacks, select "VIDEO 1 (VCnr

Perform each of the following steps within

5 seconds.

Press a numeric key.

Repeat steps 1 and 2 to register all of the

downloaded information.

^ Hold down the ENT key until the backlight

flashes twice.

» Press the 1 key to output the POWER code of the first component on

your list in step D of the previous page. Continue to push buttons 2

through 9 (and 0) until the component you want to register turns on.

»Though the FutureSet memory in your remote control is quite large,

only 10 setup POWER codes can be put on the 10 keypad at any one

time. If you require a larger download, the standard setup procedure

can be used. See "Registering setup codes for other connponents", your

customer service representative can supply you with the downloaded

setup code numbers.

■I

»The setup code for the last POWER code to be sent in step B is

automatically registered at the location selected in step □.

»At this time, the remote exits the special set-up mode and returns to

itc normal oporation mode,

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 52 53

Comentários a estes Manuais

Sem comentários

Kenwood 1070VR Manual do Utilizador Página 40

Comentários a estes Manuais