Kenwood CCD-2000 Manual do Utilizador descarregar pdf (Página 5)

English

Installation example

Install on the center part

Installation for Camera Unit

1 Clean the surface to which the rear view camera

is to be installed. Use a cloth or other item to wipe

oil, wax, dust and any other dirt from installation

surface.

2CAUTION

• Locate the rear view camera in the position you want it

installed. Adjust the angle of the rear view camera, and

install so that the camera doesn’t touch the car.

• When sticking to a glass surface, stick it on in a position

that assures the camera doesn’t touch the rear window.

2 Peel off the sheet on back of the camera bracket

(Accessory3) and stick it on.

2CAUTION

• Press the camera bracket with your fingers to stick it to

installation surface. Touching the adhesive surface or

sticking the unit on a second time reduces adhesive

strength, which may result in the unit falling.

• If the temperature of the attachment surface is low,

warm with a hair dryer or other means before installing

to improve adhesive strength.

3 Attach the rear view camera to the camera

bracket (Accessory3) with the installation screws

(Accessory4).

2CAUTION

• The rear view camera is attached so that the logo of

Kenwood is on the upper surface.

4 Adjust the angle so that bumper or rear edge of

the car is displayed at the bottom of the monitor

screen.

Glass surface

Screw (Accessory4)

Camera bracket (Accessory3)

Monitor screen

130°

96°

Bumper or rear edge of car

B64-3673-00_English.indd 5B64-3673-00_English.indd 5 07.2.2 11:13:49 AM07.2.2 11:13:49 AM

1 2 3 4 5 6 7

Sem comentários

Kenwood CCD-2000 Manual do Utilizador Página 5